Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IOS vs. BVI for 1100/350IOS configuration

Hi,

I want to restrict access to the management port ie. BVI1 using an ACL. I can't see a way to do it using the HTTP GUI so I want to do it using the CLI. My question is....are there ramifications of using the CLI instead of the GUI or vice versa? Is there a document where this is discussed?

2 REPLIES
Bronze

Re: IOS vs. BVI for 1100/350IOS configuration

There are no ramifications using the CLI instead of the GUI. Unfortunately there are no documents over this issue. Using the CLI will work fine for adding the access list.

New Member

Re: IOS vs. BVI for 1100/350IOS configuration

Ok....just wanted to confirm. I had opened a case (F048903) with TAC regarding this and it was strongly suggested that I should apply ACLs using the GUI rather than the CLI. Using the CLI makes life much easier as I can apply an ACL directly to the BVI1 interface where the GUI restricts you to the FASTE or RADIO interfaces only.

....thanks in advance....Jamie

175
Views
0
Helpful
2
Replies
CreatePlease login to create content