Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

IP address of Integrated-Service-Engine?

Is it possible to have 2800 router GigE interface subnet and Integrated-Service-Engine/wlan-controller interface in same subnet by using ip unnumbered command? I'm trying not to create a new subnet for ISE, mgmt IP, and AP mgr IP. I added them along with router static routes and NM config interface commands, but I still can't browse web admin.

1 REPLY
Bronze

Re: IP address of Integrated-Service-Engine?

can you provide the "show tech-support" from the router and "show run-config" (not "show running-config") from the WLC CLI. The ISM interface needs to be on a different subnet than the mgmt and AP-manager interfaces. If the router gigE needs to be on the same subnet as the WLC management interfaces, a BVI will be needed to bridge the router and WLC interfaces together on the same subnet.

http://www.cisco.com/en/US/docs/wireless/controller/4.2/configuration/guide/ccfig42.html

284
Views
0
Helpful
1
Replies