I have a 1552 Access point that is located out doors and would like somemore information about IP66/IP67 ratings applied to the device.
I recently moved an AP to a new location, when moving the access point i noticed the AP had a green corrision on the Alumimum on the Aerials after a week. from my understanding i belive this is a normal chemical reaction, however is there documentation that can verify this.
I have searched high and low and cannot find anything.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...