cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
597
Views
0
Helpful
0
Replies

IPv6: Error when trying to enable on WiSM

BRYN JONES
Level 1
Level 1

Hello

Following this document: https://supportforums.cisco.com/docs/DOC-18199

I am unable to enable IPv6 support on a wlan  as I keep getting this error message:

"Cannot enable IPv6-bridging when DHCP Address Assignment is enabled for WLAN"

However, to the best of my knowledge, there is no DHCP requirement mandated on the wlan.

Has anyone else experienced this and found either an explanation or a work around?

I am running 7.0.116.0 on a WiSM.

thanks

Bryn

0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: