Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Is it possible to make FEC(Fast Ehter Channel) with wiress bridge?

We have 2 catalyst2900, 2 wireless bridge.

we configured like this

Cat2950--wireless bridge ------wireless bridge---Cat2950

We want to expand wireless speed, is it possible to 4 wireless bridge with

FEC?

Cat2950 -- wireless bridge-------wireless bridge--Cat2950

--wireless bridge-------wireless bridge--

if that is not possilbe, why?

1 REPLY
New Member

Re: Is it possible to make FEC(Fast Ehter Channel) with wiress b

Yes it is possible. I do it between Catalyst 5509 and 3548 XL. Works just fine although you cannot telnet to bridges.

Apparently this is not a Cisco supported design.

Cisco has different solution using routers on either end so that router will load balance plus you have remote admin capabilites.

There should be a white paper on design in CCO.

195
Views
0
Helpful
1
Replies
CreatePlease login to create content