Issue setting Primary Controller IP Address on Prime 2.0
I have a problem with a AP template on Prime 2.0.
I have a WLC pair (220.127.116.11) setup as N+1. Now on the Prime (2.0) I created a Lightweight AP Configuration Template, setting the Primary and Secondary Controller name (from Dropdown) and pasted the IP Addresses of these controllers to the appropriated fields.
I also set the AP Failover Priority to Medium.
That is all in the template.
Saved the template. Selected (the only) one AP on this WLC's to apply the template. hit Apply, status says "Success".
Checking the AP, the controllers and Failover Prio are set but the IPAddress fields are empty.
Back to the Prime template, the IP Adresses are set to 0.0.0.0 again.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...