Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Issues with 2nd VLAN on WLC 4408

HI all,

I have been experiencing issues trying to connect to other devices outside of the vlan defined on the controller. I have the following set up on the controller:

Interfaces:

Name          VLAN ID          IP Address          Interface Type          Dynamic AP Management

ap-manager     100              192.168.100.12         Static               Enabled

int_vlan10        10               192.168.8.3               Dynamic          Disabled

int_vlan20        20               10.201.24.3               Dynamic          Disabled

management    100             192.168.100.11          Static              

service-port                         192.168.1.1

virtual                                 1.1.1.1

VLAN 10 connects through a fibre switch to an ADSL router and works ok, VLAN 20 connects directly to an access port on my core switch. I can ping anything within the subnet (actually only the wlc and core routed interfaces) of VLAN 20 but not outside (I want to authenticate WLAN users against an LDAP server which is directly connected to the core also). There are no ACL's on either the wlc or the core switch. Controller is LAG mode, and I have defined the specific interface for the SSID.

I would really appreciate any suggestions on why it's no working.

Thanks.

1 ACCEPTED SOLUTION

Accepted Solutions

Issues with 2nd VLAN on WLC 4408

Hi,

The controller is in LAG mode, you need to remove this so the controller doesn;t try to aggregate the connections.

Once you have done this you can assign VLAN interfaces to the port.

Thanks

Chris

2 REPLIES

Issues with 2nd VLAN on WLC 4408

Hi,

The controller is in LAG mode, you need to remove this so the controller doesn;t try to aggregate the connections.

Once you have done this you can assign VLAN interfaces to the port.

Thanks

Chris

New Member

Issues with 2nd VLAN on WLC 4408

Thanks Chris. You are the man!

145
Views
0
Helpful
2
Replies
CreatePlease login to create content