I just got the 1130 AG's in and I plugget it into the network. It got an IP address from DHCP because I can see it in the address leases with its MAC address. I can ping it but I can't web browse to it.
It is in a different part of the building than where my my 4400 swithc is. I have a 4500 core cisco switch and 3650 gig switches on my network.
I read somewhere where in the first 5 minutes you have to hit the 10.0.0.1 address.
It has an ip address, I can get into it with the console. I made it shut up by putting a dns entry in for my wireless controller. I cannot get into it with a web browser, I can ping it, and I am in the command line with the console cable. All pretty much worthless and the documentation is worthless as I type in the IP address that I know is the device and it can't find the AP
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...