I have 1 AP out of ten not joining the controller. I connected the access point to the network and I checked its boot. the access point reaches LWAPP Discovery" and then give me console input. I hard reset the access point and I hard coded an IP address for the AP the AP joins the controller, but when I reset it to assign it to another controller it did not join again.
why the discovery process is not showing the DHCP option 43 configured and DNS for CISCO-LWAPP-CONTROLLER configured on the DNS. All the access point is operating normally except this one. it has many certificate inside, why a hard reset did not work to solve the problem?
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...