Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

LAP1142 looses config after power cycle

We have some 1242 LAPs in a two 5508 controller setup working fine. All LAP are configured to obtain address from DHCP. After first join we usually change some configs like HOSTNAME, AP GROUP, PRIMARY AND SECONDARY WLC. After a software restart or a complete power off/power on the LAPs joins the primary controller and all configuration still there. We now add a 1142 LAP and is does not retain the configuration after a power off/power on cycle, but after a software restart there is no problem. The only way to retain the config is setting the AP with a static IP address.

We use WLC 7.0.116 and we see no errors in the LAP console.

Best Regards,

Augusto

Everyone's tags (5)
1 REPLY
Hall of Fame Super Silver

Re: LAP1142 looses config after power cycle

I would just open a tac case as it might be an issue with the APs itself.

Sent from Cisco Technical Support iPad App

-Scott
*** Please rate helpful posts ***
216
Views
0
Helpful
1
Replies
CreatePlease to create content