This is my first time to configure AP, I configure the access point using the basic setting, no security. After configuration, my pc with wireless can find the SSID, but not able to connect to network. Message is "limited or no connectivity", What is the possible problem?
Can you confirm that you can reach the default gateway from the access point to prove IP connectivity on the LAN interface?
If so the message you are seeing on the client could just be down to not receiving an IP address via DHCP? You will need to ensure that the DHCP server is reachable from the VLAN the wireless AP is connecting to, either on the same subnet or via a router with DHCP-relay (IP helper address on Cisco routers) enabled to ensure your DHCP requests are being forwarded.
If DHCP is already set up, you can test it by connecting the PC to the LAN port that currently connects to the AP - if you get an IP address here then we need to look more closely at the AP configuration.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...