If you let me know what you want to achieve with the AP, I could try to provide you to steps to configure the AP as needed.
As basic information remember that the access points are layer 2 devices . To be able to configure the unit you need that the unit gets an IP address from the DHCP server on the network and you access the AP via the GUI or CLI using the IP address the DHCP server gave it or if not you can also configure an static IP address on the unit using the console port and assign the required IP address to the BVI1 interface.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...