Just unboxed a brand new location Applinace and following the setup steps. when I get to where I have to configure the ifcfg-eth0 file I put in all the changes and try to save and I get a E212: Can't open file for writing error message. I can not get it to work on either interface, I have RW permissions on the file. Does anyone have any suggestions, I am not famillar with redhat so will need detailed instructions of the commands if so be.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...