Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

LWAP 1042

I have a Cisco Air-LAP 1042N that I need to set back to factory defaults after I installed another firmware version in hopes of doing everything through the broswer. Well some how that blocked my ability to see the AP on the WLC. Can someone send me a link for the 'out of the box' version of the firmware please

I just want to make sure that I have the correct version

Thanks you

Everyone's tags (2)
Hall of Fame Super Silver

Re: LWAP 1042

What exactly did you do? Can you access the console at least? If so, you can tftp the lightweight recovery image back to the AP. Here is a swupport doc that should help.

Sent from Cisco Technical Support iPad App

*** Please rate helpful posts ***

LWAP 1042

Try installing the autonomous mode iOS on the AP then convert it to lightweight version again.

Here is a doc:

Rating useful replies is more useful than saying "Thank you"
CreatePlease to create content