LWAP 1142N convert to autonomous

[jeff_reilly]

When I am tftping the new IOS it suddenly times out, I then see that the static ip address that I set on Gi0 is gone and "ip address dhcp client-id GigabitEthernet0" is back in the interface config. Question is how do I stop this happening so I can complete IOS tftp transfer

[Sandeep Choudhary]

Set IP on Interface Gi0 and also configure default gateway.

If its changing frequently then configure above steps and save it.

then follw this method:

http://rscciew.wordpress.com/2014/05/07/access-point-conversion-lap-to-aap-and-vice-versa/

http://www.youtube.com/watch?v=QQ_NuxdRhQ4

Regards

[jeff_reilly]

Hi Sandeep

doesnt save config I get..

APf866.f244.72b8#wr mem
Building configuration...
[OK]
NVRAM Verification Failed
 

It just keeps forcing the DHCP config on

[LJ Gabrillo · Accepted solution]

Do this:

Note some of these are hidden commands, Meaning TAB does not work :)

on LWAPP AP:


debug capwap console cli       -CLI Mode

debug capwap cli no-reload    -stops it reloading

**Assign IP:
capwap ap ip address <IP> <SM>

capwap ap default-gateway <IP of your TFTP Server/typically your PC>

**Transfer

archive /download-sw tftp://<IP>/filename.tar

:)

[jeff_reilly]

Thank you Isagabrillo, thats fixed it, for two days I've been struggleing with that!

The no-reload command I think was the fixer!

thanks again

and thanks to Sandeep too :)

[LJ Gabrillo]

Glad to help :)