Hello...I am having issues with clients who are connecting to LWAPP APs. They are not able to obtain an IP address via DHCP. If I give them a static address on the VLAN they are trying to connect to, they get on fine. The WLC is handing out the IP addresses to the access points, however, the wireless clients are to be getting them from a Windows server. If I wire a client in the network and put the switchport on the VLAN, I can get an address. I have the IP helper address on the VLAN interfaces where it should be. Is there something I need to config on the controller? Is there something on the Windows DHCP scope?
Make sure you have the DHCP server ip address configured in the interface in which the wireless clients will be on. Next I would verify that the management and ap-managers interface vlan identifier is set to "0" (untagged native vlan) and configure the trunk port in which the WLC connects to configured the native vlan.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...