03-26-2014 01:49 PM - edited 07-05-2021 12:33 AM
Hi,
I have a few LWAPP model number: cap2602i-a-k9. I am tasked with registering these access points across a site to site VPN where the WLC is located.
I am not sure how these access points should be configured, whether it should be done statically and using autonomous mode, or if possible with the H-REAP feature.
The WLC is a 5508.
Any input would be helpful.
Thanks,
Waqas
Solved! Go to Solution.
03-26-2014 02:01 PM
Hi,
Yes it can be configured as HREAP mode. You must create a DHCP pool for APs to get ip on remote location.
There must be a way configured for APs to search for WLC.
http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-lan-wlan/81680-hreap-modes.html
http://www.cisco.com/c/en/us/support/docs/wireless/5500-series-wireless-controllers/71250-h-reap-design-deploy.html
Regards
Dont forget to rate helpful posts
03-26-2014 02:01 PM
Hi,
Yes it can be configured as HREAP mode. You must create a DHCP pool for APs to get ip on remote location.
There must be a way configured for APs to search for WLC.
http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-lan-wlan/81680-hreap-modes.html
http://www.cisco.com/c/en/us/support/docs/wireless/5500-series-wireless-controllers/71250-h-reap-design-deploy.html
Regards
Dont forget to rate helpful posts
03-26-2014 03:21 PM
Thanks Sandeep
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide