Hi Sir,
Currently trying to setup a demo to demonstrate the WCS functionality.
I tried to set up LWAPP wireless using an IOS-based AP 1200 with .g radio module, a 2006 Controller (ver 3.2) and a laptop client with wireless LAN card and wired LAN card.
I have downloaded the following in order to proceed with my demo to customer
- C1200-rcvk9w8.123-7.JX.tar ( is needed to upgrade IOS to LWAPP)
- CiscoAironet-AP-to-LWAPP-Upgrqade-Tool-v10.exe
From the IOS to LWAPP Migration techniques,I need to ensure that my AP 1200.g is able to ping the Controller and vice versa.
The laptop is connected to port 1 on WLC 2006.
The AP is connected to port 2 on WLC 2006
I have set the following IP addresses
10.2.10.1/24 - WLC 2006 Management IP, Port 1 is assigned to management
10.2.10.127/24 - AP 1200 with .g radio
10.2.10.100/24 - Laptop wired client
I can ping from my Laptop(10.2.10.100) to WLC 2006 (10.2.10.1) but I can't ping the AP. What is the reason?
If there is no connectivity between WLC and AP then I am not confident of converting the IOS-based to LWAPP with the version listed above.
If I connect to laptop to port 3 or 4, I can't ping the WLC 2006. I found out only if I connect the AP or Laptop to port 1 on the WLC 2006, then there is connectivity to the WLC 2006. Port 2, 3 and 4 do not seem to work.
Thank you.
Delon
