Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

LWAPP, WLC and WCS demo

Hi Sir,

Currently trying to setup a demo to demonstrate the WCS functionality.

I tried to set up LWAPP wireless using an IOS-based AP 1200 with .g radio module, a 2006 Controller (ver 3.2) and a laptop client with wireless LAN card and wired LAN card.

I have downloaded the following in order to proceed with my demo to customer

- C1200-rcvk9w8.123-7.JX.tar ( is needed to upgrade IOS to LWAPP)

- CiscoAironet-AP-to-LWAPP-Upgrqade-Tool-v10.exe

From the IOS to LWAPP Migration techniques,I need to ensure that my AP 1200.g is able to ping the Controller and vice versa.

The laptop is connected to port 1 on WLC 2006.

The AP is connected to port 2 on WLC 2006

I have set the following IP addresses

10.2.10.1/24 - WLC 2006 Management IP, Port 1 is assigned to management

10.2.10.127/24 - AP 1200 with .g radio

10.2.10.100/24 - Laptop wired client

I can ping from my Laptop(10.2.10.100) to WLC 2006 (10.2.10.1) but I can't ping the AP. What is the reason?

If there is no connectivity between WLC and AP then I am not confident of converting the IOS-based to LWAPP with the version listed above.

If I connect to laptop to port 3 or 4, I can't ping the WLC 2006. I found out only if I connect the AP or Laptop to port 1 on the WLC 2006, then there is connectivity to the WLC 2006. Port 2, 3 and 4 do not seem to work.

Thank you.

Delon

287
Views
0
Helpful
0
Replies