I've set up a 1240 as AP with 2 VLANs, works fine. But our network uses VLAN 200 as management, not VLAN 1. I configured int BVI200 and gave it an IP address, but cannot get any IP connectivity. If I use BVI1, everything works, but on the wrong VLAN. How can I manage my AP on another VLAN?
I use VTP Prunning in the network, and when configure the native vlan (200) in the interface trunk (Switch for AP), this generated another problem. All the vlans appear in the interface trunk on the switch, but this not is ok, because should appear only in the interface trunk the vlans as configurated on the access interfaces on the switch.
The situation appear because i have change the native vlan (Vlan 1 to vlan 200)on the switch.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...