04-16-2012 02:48 PM - edited 07-03-2021 10:00 PM
I have an access point 1310. I want to add to the WLC as an access point. It have been configured with IP address correctly and the radio interface is up. I need to add it to the WLC as CAPWAP. Does anyone give me some helps to do this process please. I dont have much experience with provisioning the AP.
Thank you very much.
04-16-2012 03:04 PM
Just make sure the WAP and the WLC are in the same VLAN.
04-16-2012 03:24 PM
I do have both of the WAP and WLC on the same VLAN. Now do i run configure AP from the WCS? Or does it push the configuration automatically?
How do I check it is associated with WLC?
04-16-2012 03:30 PM
On the WLC's main page, will show you how many aps have joined the WLC, or else you can click on the wireless tab and view them there. Is this the only AP you have on this WLC?
04-16-2012 03:48 PM
I could not find where it shows how many aps have joined? I can see the total APs not yet assigned to MAPs but there is not an ap that I connected.
I have more aps online beside this. This AP was online and corrupted image and I just recovered. Now I need to add it back to WLC.
BTW, I dont see the wireless tab and view them.
The screen I have are Monitor, Reports, Configure, Services, Administration, Tools and Helps.
Do I select configure and AP configuration template to provision it?
Thank you
04-16-2012 03:50 PM
You need to look at the wlc not WCS.
Thanks,
Scott Fella
Sent from my iPhone
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide