Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Master Controller Mode question

I am new to the wireless LAN controller world so I have a question.

we just bought and configed a 2006 controller. we don't have any APs connected to it yet(waiting on antennea). I am presumming that I should have the setting Master Controller Mode set to "enable". Right

Gary

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: Master Controller Mode question

Gary,

This setting is not necessary in your environment. I would leave it disabled. This setting only comes into play when there are more than one controller the AP can connect to and it hasnt been specifically specified which controller is primary or seconday. In such a scenario the "Master" controller setting is the tie breaker.

Hope this helps. Please rate this post :)

-Brad

1 REPLY
Silver

Re: Master Controller Mode question

Gary,

This setting is not necessary in your environment. I would leave it disabled. This setting only comes into play when there are more than one controller the AP can connect to and it hasnt been specifically specified which controller is primary or seconday. In such a scenario the "Master" controller setting is the tie breaker.

Hope this helps. Please rate this post :)

-Brad

3355
Views
0
Helpful
1
Replies
CreatePlease login to create content