Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Migrating all AP's to FlexConnect

I have about 60 AP's connected to my WLAN controller and want to migrate these to Flexconnect.  Do I have to manually changed each AP individually to FlexConnect or is there a way on the controller to configure them all in one easy way?  I plan to establish new SSID's that will be used via FlexConnect and keep the two existing SSID's as central switched until all users are migrated to the new SSID's.

Thank you.

1 ACCEPTED SOLUTION

Accepted Solutions

Unless you have a 7510 you

Unless you have a 7510 you can use the auto convert commad

http://www.cisco.com/c/en/us/td/docs/wireless/controller/7-6/command-reference/b_cr76/b_cr76_chapter_01011.html#wp2218723240

 

if you have a 5508 or other, than you will need to do each one manually.

But you can script it:

config ap mode flexconnect < ap name >

 

HTH,

Steve

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
2 REPLIES

Unless you have a 7510 you

Unless you have a 7510 you can use the auto convert commad

http://www.cisco.com/c/en/us/td/docs/wireless/controller/7-6/command-reference/b_cr76/b_cr76_chapter_01011.html#wp2218723240

 

if you have a 5508 or other, than you will need to do each one manually.

But you can script it:

config ap mode flexconnect < ap name >

 

HTH,

Steve

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
New Member

Thank you.

Thank you.

166
Views
0
Helpful
2
Replies
CreatePlease to create content