The release notes specify that you must break your HA pair before upgading, but I am not aware of a recommended procedure to do that. I am also looking to find experiences from anybody who has upgraded and has any insights good or bad in relation to 7.5. I know it has only been out for a short time but please post any testing you have done with HA. If on the upgarde it is just that the secondary goes into maintenace mode then can this be overcome without breaking the HA setup upgrade? Given the fact that this was just one line hidden in release notes I am guessing somebody may have mistakenly just upgraded and I am curious what the results were.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...