Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Missing WLC in Prime

Hi, a few days ago one of my anchor controllers dropped out of Prime and became unreachable (for no apearant reason) The WLC was still up and on the network but prime thought it was down. I check SNMP strings and even reloaded but to no avail.  I removed the WLC from Prime then did a re-discovery which said that it worked BUT the WLC is not showing in monitor/config pages in any of the domains including ROOT. I treid to re-discover again and it says it is already in Prime. I am running 1.3. (going to 2.1 soon hopefully) This happened once before but I am at a loss as to how I remedied it... I am looking in the Admin pages to see what I can find, any ideas? Thx

1 REPLY
VIP Purple

Try to delete the WLC from

Try to delete the WLC from prime & re-added.

In life Cycle view you can do that under "Operate -> Device Work Centre". Even PI says unreachable, that device should be listed there. Then delete first & then add it again.

 

HTH

Rasika

**** Pls rate all useful responses ****

23
Views
0
Helpful
1
Replies
CreatePlease to create content