Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Mobility between HREAP and NON HREAP does not work..

HREAP Local Switch and Auth has been enabled on SSID.

Indoor AP is in HREAP mode.

Outdoor AP does not support HREAP mode.

Client connects to indoor AP....continous PING breaks after client roams to outdoor AP. The state of the client is RUN.

Disable HREAP Local Auth and the issue goes away.  Why?

  • Getting Started with Wireless
6 REPLIES
Silver

Mobility between HREAP and NON HREAP does not work..

Please confirm:

This is an Intra-Controller roam (two APs on the same WLC)

The Local Switching VLAN on the HREAP is the same Vlan mapped to central switching on the WLC?

I'm not sure whether it is expected to work or not between hreap and non hreap, but as long as the vlans are the same I dont see any reason why it wouldnt work.

Perhaps you could do a "debug client "  on the WLC when the client first roams to HREAP and then roams to the Local Mode.

New Member

Re: Mobility between HREAP and NON HREAP does not work..

Thanks for the reply!

TAC looked at the debugs and said it should work but it does not.

Yes this is intra controller roam. Same VLAN is mapped.

The issue goes away if i uncheck local auth so all above mentioned parameters are correct.

New Member

Re: Mobility between HREAP and NON HREAP does not work..

Another observation...When HREAP is enabled on SSID and Local Auth is selected..is it possible that it is enforcing 100% this setting eventhough the AP is not in HREAP.

So the same issue was noticed between two indoor AP's one in HREAP and another in HREAP.

New Member

Mobility between HREAP and NON HREAP does not work..

This is a bug in 7.116 code..works for 7.220

Mobility between HREAP and NON HREAP does not work..

Without HREAP config, you will not be able to do local-auth on the AP

The design guid says roam between a HREAP and non-HREAP will not work,

Thanks

NikhiL

New Member

Re: Mobility between HREAP and NON HREAP does not work..

Does not work in 7.0.220 code either. Finally TAC filed a bug CSCty39231 to track this.

In 7.0.220 based on testing methodolgy, roaming works..if you disable an AP and force client to roam to another AP then roaming works between HREAP and non HREAP.

495
Views
0
Helpful
6
Replies