Multiple SSID on 1242

[AlexioUBS]

Dear Sirs.

I have 1242AG access point. I need to create two SSIDs for different types of devices. I create one SSID with WPA TKIP security and another one without security. I create two VLANs for each SSID, one of the VLANs is native VLAN.

In event log I see that devices associate to both SSIDs. However, I can ping from the network only the device which is assigned to Native VLAN.

When I switch Native VLAN to another SSID, devices within this SSID are being seen from the network, devices within second SSID are not seen (and vice versa).

Pleae advise.

[Richard Atkin]

Could be a whole host of things... Easiest option is to post the switchport config from the switch, and the AP config.

Failing that, check that...

VLAN tags & encapsulation types are correct.

Routing is setup correctly

No ACLs / Firewalls

Bridge Groups setup correctly (Native VLAN is normally reserved for BVI 1, and not mapped to an SSID)