Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Mutiple SSID with Mutiple VLAN - Sample Configuration required 800 Series Routers

Hi All,

I am trying to figure out how to configure mutiple ssid and vlans for 800 series router.

I found a sample configuration on support forum.

https://supportforums.cisco.com/docs/DOC-26197

Since i am using mutiple vlan with mutiple brige-group numbers.

e.g.

!

interface Dot11Radio0.1

encapsulation dot1Q 1 native

  no ip route-cache

bridge-group 1

bridge-group 1 subscriber-loop-control

bridge-group 1 block-unknown-source

no bridge-group 1 source-learning

no bridge-group 1 unicast-flooding

bridge-group 1 spanning-disabled

!

interface Dot11Radio0.2

encapsulation dot1Q 2

no ip route-cache

bridge-group 2

bridge-group 2 subscriber-loop-control

bridge-group 2 block-unknown-source

no bridge-group 2 source-learning

no bridge-group 2 unicast-flooding

bridge-group 2 spanning-disabled

!

interface Dot11Radio0.3

encapsulation dot1Q 3

no ip route-cache

bridge-group 3

bridge-group 3 subscriber-loop-control

bridge-group 3 block-unknown-source

no bridge-group 3 source-learning

no bridge-group 3 unicast-flooding

bridge-group 3 spanning-disabled

!

Q1.Do i need mutiple IRBs?

Q2. Are IRB configuration required on both AP and Router?

e.g.


bridge irb

bridge 1 route ip

bridge 1 protocol ieee

bridge 2 route ip

bridge 2 protocol ieee

bridge 3 route ip

bridge 3 protocol ieee

--

Thanks.

2 REPLIES
Hall of Fame Super Silver

Mutiple SSID with Mutiple VLAN - Sample Configuration required 8

You only need it on the AP side.

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

-Scott
*** Please rate helpful posts ***
Cisco Employee

Mutiple SSID with Mutiple VLAN - Sample Configuration required 8

More configuration for the same is present at the below support link:-

https://supportforums.cisco.com/docs/DOC-14496

Also Bridge IRB is needed on the AP side....

176
Views
10
Helpful
2
Replies
CreatePlease to create content