Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

NCS Planning Mode

I have a question about Cisco Prime NCS Planning Mode.  When I plan for 802.11an and 802.11bgn, for example, there is a floor that will require 6 access points.  If I uncheck 802.11bgn, and leave 802.11an, then it only requires 4 access points.  Not sure why that is.  I have an idea, but would like someone to explain it to me.  Also, If I check "voice" and no data, it only requires 4 access points too.  I would think that voice would require more access points, not less.  Can someone explain that too?  Thanks.

1 REPLY
Cisco Employee

NCS Planning Mode

149
Views
0
Helpful
1
Replies
CreatePlease to create content