Cisco Support Community
Community Member

Need help on register AP to WLC

I have an LAP on the same subnet with the WLC. I can ping the AP from the controller and everywhere on the same subnet. But I can't see it join to the WLC. I checked the command on WLC:

(Cisco Controller) > show ap join stats summary all

but the LAP does not show on the list. I ran this with MAC address of the AP

(Cisco Controller) > show ap join stats summary MACADDRESS

but I can't find the AP either.

the AP is running C1310-k9w7-mx.123-8.JEA3

On the AP, I ran set command, it shows:

ap: set IP_ADDR ....etc correctly with my address to setup

Some documentation shows the command ap1310>capwap ap ip address So when should I start  using these command?

How do i correct this problem so my ap can join?

I am really appreciated for your help


Hall of Fame Super Silver

Need help on register AP to WLC

You need to be running a lightweight code on that 1310 not an IOS.

*** Please rate helpful posts ***

Need help on register AP to WLC

To piggy back on Scotts comment.

The 1310 can be ran as autonmous OR lightweight.

* Note -- 1310 will not working on 7.2 WLC code, shold you use these in a lightweight environment.

"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin
CreatePlease to create content