Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

need info regarding light weight AP 1042 registration

hi ,

I ordered controller 2504 and will arive soon. I want to know that after configure the initial setup of 2504 (i.e. AP manager , Managment IPs etc) and defining the DHCP for AP. Will the 1042 lightweight AP will register with the controller automatically or i need to manually define the AP (MAC address) on WLC. and also whether the Option 43 and 60 are correctly defined?

Management Interface: 10.10.22.15

AP Manager Int: 10.10.22.16

ip dhcp pool WLAN103

network 10.10.3.0 255.255.255.0

default-router 10.10.3.1

option 60 ascii "Cisco AP c1040"

option 43 hex f104.0a0a.1610

dns-server 10.10.3.1
ip dhcp pool WLAN103
network 10.10.3.0 255.255.255.0
default-router 10.10.3.1
option 60 ascii "Cisco AP c1040"
option 43 hex f104.0a0a.1610
dns-server 10.10.3.1

port-channel load-balance src-dst-ip


interface range gig 2/38 - 41
  switchport
  channel-group 13 mode on
  no shutdown

interface port-channel 13
  switchport
  switchport trunk encapsulation dot1q
  switchport trunk native vlan 1
  switchport trunk allowed vlan 1,122,103,113,1002 - 1005
  switchport mode trunk
  no shutdown

Regards

Naray

4 REPLIES
Hall of Fame Super Silver

Re: need info regarding light weight AP 1042 registration

You don't need an ap manager with the 2504. Also the 2504 does not support LAG so you can have an etherchannel.

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
Hall of Fame Super Silver

Re: need info regarding light weight AP 1042 registration

Take a look at this 2504 config guide

http://www.cisco.com/en/US/products/ps11630/products_tech_note09186a0080b8450c.shtml

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
Hall of Fame Super Blue

need info regarding light weight AP 1042 registration

Make sure the WLC is running, at least, 7.0.98.0 to be able to recognize and support the 1040.

Community Member

need info regarding light weight AP 1042 registration

Hi Naray,

I just setup my wireless network with 2504 WLC and 1142 AP's. I don't have to define option 43 or 60 for DHCP i think you need to do this if you have more than one dhcp scope or if you create new scope for wireless.

In my case i use my old dhcp scope and i just configured wlc with external dhcp and AP joined straight  away. One issue i had was AP wasn't joinging the WLC because of wronge time and date on wlc. Its prety straight forward hope it goes well for you.

431
Views
0
Helpful
4
Replies
CreatePlease to create content