Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Need to configure AP 1252 as L2

Hi,

Currently we have a scenario [DHCP server à switch à WCS 2125 à AP 1252 à Laptop]. Currently the Access Point and the Laptop getting Ip from DHCP server now i want to use this AP as a L@ device i mean in layer 2.

1 REPLY
Cisco Employee

Re: Need to configure AP 1252 as L2

Not entirely sure what you are trying to do, but I will take a stab at it.  If you do not which to have the AP joined to the WLC and have it operate as a standalone AP, which means it will be a L2 bridge, you will have to convert the AP to autonomous mode.

If you simply want to have your client traffic be bridged direclty by the AP to the wired network and not go back to the WLC, but keep the AP managed by the WLC, you will need to setup H-REAP.

H-REAP

http://www.cisco.com/en/US/docs/wireless/controller/7.0/configuration/guide/c70hreap.html

Lee

391
Views
0
Helpful
1
Replies