Netflow on 2600 Series AP's?

[helpling]

Hi there!

Just wondering if it's possible to configure a 2600 series AP with Netflow to send traffic flows.

I have several AIR-SAP2602I-E-K9's , operating autonomously.

Software Version: 

ap3g2-k9w7-xx.153-3.JBB

Can't find much documentation on this. Looking like I would need a controller for this perhaps?

Any help appreciated!

Thanks

[Rasika Nayanajith · Accepted solution]

Netflow is only supported on L3 device. So you cannot configure AP to send netflow data (as AP is a L2 device)

You have to configure netflow on the device where you defined SVI for wireless users. 

HTH

Rasika

*** Pls rate all useful responses ***

[helpling]

Makes sense. Thanks