Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

new ap's in cisco wcs

Hi,

I have added few new access points to our wireless network. We have an existing WCS.

what steps are required to add the new access points on the wcs so the maps reflect the new ones.

Thanks in advance.

1 ACCEPTED SOLUTION

Accepted Solutions

new ap's in cisco wcs

Hi,

Here are the steps:

http://www.cisco.com/en/US/docs/wireless/wcs/7.0/configuration/guide/7_0maps.html#wp1126390

HTH

Amjad

Rating useful replies is more useful than saying "Thank you"
2 REPLIES

new ap's in cisco wcs

Hi,

Here are the steps:

http://www.cisco.com/en/US/docs/wireless/wcs/7.0/configuration/guide/7_0maps.html#wp1126390

HTH

Amjad

Rating useful replies is more useful than saying "Thank you"
Community Member

new ap's in cisco wcs

Case Solution:

Step 1 Choose Monitor > Maps.

Step 2 From the Maps Tree View or the Monitor > Maps list, click the applicable floor to open the Floor View page

Step 3 From the Select a command drop-down list, choose Add Access Points, and click Go.

Step 4 On the Add Access Points page, choose the access points to add to the map.

Step 5 Click OK to add the access points to the map and display the Position Access Points map

Step 6 When all of the applicable access points are selected, click OK located at the bottom of the access point list.

Step 7 Click and drag each access point to the appropriate locations. Access points turn blue when selected.

Step 8 When you are finished placing and adjusting each access point, click Save.

For more information please review the below link:
http://www.cisco.com/en/US/docs/wireless/wcs/7.0/configuration/guide/7_0maps.html#wp1126390

299
Views
5
Helpful
2
Replies
CreatePlease to create content