Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

new setup with Aironet 1240AG

Hi

I have setup new aironet 1240G with stellbelt Radius server EAP authentication and no WEP (for now).

Using Dell lattitude 610 - builtin wireless adapter and software, i am getting the SSID in available network, but when i tries to connect, it does not ask for authentication and just keep saying 'acquiring network address' for ever. Please advise.

Also i am wondering where to specify DHCP service details for wireless clients. (i am using GUI admin)

thanks

regards

rakesh

======

2 REPLIES
Silver

Re: new setup with Aironet 1240AG

When the controller boots at factory defaults, the bootup script runs the configuration wizard, which prompts the installer for initial configuration settings. Follow these steps to enter settings using the wizard on the CLI:

Enter the IP address of the default DHCP server that will supply IP addresses to clients and the management interface if you use one.

Management Interface DHCP Server IP Address: 10.0.2.24

http://www.cisco.com/en/US/products/hw/modules/ps2797/products_feature_guide09186a008059a53b.html

New Member

Re: new setup with Aironet 1240AG

Thanks for the reply. I then gave this command at CLI. regards, Rakesh.

418
Views
0
Helpful
2
Replies
CreatePlease login to create content