Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Newbe to AP350

In the power setup for the Cisco Aironet Access Points 350, it shows how power is to be supplied to the 350. My question is - why is the ethernet connection from the power injector to the switch (without inline power) needed? I think I understand why the connection from the power injector to the AP is needed but not the other connection.

1 REPLY
Cisco Employee

Re: Newbe to AP350

Hi ,

power injector is used to supply the power through ethernet .

Power injector has two ethernet connector one going to switch and one going to AP

So packet travells from switch to power inector and power injector to AP ...

So cable between power injector and switch is to carry etherent packet from switch to AP ....

so under normal condition

wall- power adapter--Ap------ether cable ------switch

now with power injector

---------------------------------------------

|

Power plug

|

|

AP------------ power injector ----------Switch ---backbone

I hope this helps

Nilesh

146
Views
0
Helpful
1
Replies
CreatePlease login to create content