Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Nexus and a 5508

Anyone setup a 5508 and a Nexus 5548P yet?  Anything I should know about, or do I just make the usual port channels?

Regards,
Scott

  • Getting Started with Wireless
4 REPLIES
Cisco Employee

Re: Nexus and a 5508

Hi Scott,

nothing special normally. Just make the etherchannel load balancing as "src-dst-ip" and you should be good to go.

Also remember to not put any portchannel negociation, just mode "on".

Nicolas

===

Don't forget to rate answers that you find useful

New Member

Re: Nexus and a 5508

Hey Scott,

Also make sure you use "spanning-tree port type network" on the Nexus side.

New Member

Re: Nexus and a 5508

Thanks Kyle.  Is there any guide for connecting to a Nexus, or do I just have to pay attention to the protocols/technologies in use?

Regards,
Scott

New Member

Re: Nexus and a 5508

There's no guide that I know of just pay attention to the same basics as you would for an etherchannel to a 6500 for example with the addtion on the above spanning-tree command and be sure to use "mode on" for the port channel. HTH. Good luck!

353
Views
0
Helpful
4
Replies