Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

No console output on 4404

Setting up a 4404 and plugged in to console and I get no output... The status light is solid and then blinks and then goes out - sounds normal. I used a rollover to DB9 connector, tried a couple of different connectors, and even tried a 232 connector with no luck.

First time with a 4404. Is it a brick, or does it take 15 minutes to boot? Checked my serial settings to be sure and all good. Thanks for any help...

1 REPLY

Re: No console output on 4404

Hi Mike,

You want to use a null modem cable ONLY for console. It takes 3 - 4 minutes to load... Try the null modem cable and see if that works for u

__________________________________________________________________________________________ "Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin ___________________________________________________________
251
Views
0
Helpful
1
Replies
CreatePlease login to create content