Usually indicates that the client hasn't authenticated with the AP correctly and if using static WEP (which I think you are) that the WEP key is wrong somewhere. Re-enter on the AP and clients and try again.
You will see an association, but no authentication if the WEP key doesn't match. Type the wep key into both client and AP again. WEP key shouldn't be pasted into an AP. I've seen issues with this. Make sure you use the same index on both ends.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...