cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
165
Views
0
Helpful
3
Replies

No traffic on AP using wep key

aperezsts
Level 1
Level 1

hi,

I have a Cisco AP1600I (AIR-SAP-1602I-T-K9). I setup a open ssid and the AP works fine. Here's the configuration:

dot11 ssid network1
   vlan 1
   authentication open
   mbssid guest-mode
int dot11Radio0.1
  encapsulation dot1Q 1
  bridge-group 1
int g0.1
  encapsulation dot1Q 1
  bridge-group 1
int dot11radio0
  ssid network1
  no shutdown

 

When I use the following configuration to create a WEP Key, I cannot receive IP from my DHCP server:

int dot11radio0
  encryption vlan 1 key 1 size 128bit 0 11111111111111111111111111 transmit-key
  encryption vlan 1 mode wep mandatory

 

Thanks in advice.

 

3 Replies 3

Why WEP ? Is this a test lab set up? If it is for a production network you should NOT use WEP.

If this is for testing you can refer this.

http://mrncciew.com/2013/03/02/autonomous-ap-with-wep-security/

HTH

Rasika

**** Pls rate all useful responses ****

Hi! This a legacy environment. We are replacing some old access points and handheld products. I've already tried your suggestion and it didn't worked for me. Do you have any other idea?

Thanks for your help.

What brand handheld product are these ? did you check that product does not support anything other than WEP.

Also if you set it to Open Authentication without any security does these device get connected ?

HTH

Rasika

**** Pls rate all useful responses ****

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: