So the DHCP works just fine for the Fast Ethernet Interfaces but the Radio interface doesn't seem to work. I want to have 2 Vlans, 1 for the wireless and 1 for the wired as well as having them both on different subnets (doesn't matter the value) can anyone point me in the direction I need to go? I'd like to not have to bridge anything for that seems easier. Thanks
Your configuration seems to be correct for me. But is the client associating without IP address. I mean client will associate with least connectivity. Also, I am not sure about "ip nat inside" command. I think this configuration might be a problem for wireless network.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...