Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

OEAP 600 bridging dual-rlans?

I have established dual-rlans on different segments.

I have a 2960g switch.  I created vl2 (management) and vl3 (data).

I connected rlan1 (port4) to vl2 and rlan2 (port3) to vl3.

My laptop receives a dhcp address on vl3 and the switch (in dhcp mode) receives it's proper address on vl2.

Unfortunately a MAC is assigned to each vl and to the management interface.  Thats 3 out of the 2 sets of 4.

So a managed switch is NOT the desired device to have on the back side of an OEAP600.

In any case doing a show mac address-table revealed that all the vl2 MAC addresses were duplicated on vl3.

To the tune of 216 addresses.  108 in each vlan.  Which is a close match to the current host counts for each segment

98 + 18.

Obviously this application is not what was envisioned by the OEAP team during work-up.

The goal of 4 host devices on the rlan is proving difficult to achieve.

The client wants 2 pc's and 2 digi-port servers.

Everyone's tags (4)
1 REPLY

OEAP 600 bridging dual-rlans?

OK switched to a 3560 and routed mode...

and with just the link to the 600 the switch reports:

"%ETHCNTR-3-LOOP_BACK_DETECTED..

and err-disables the port.

I set no keepalives and the problem is gone.  So the 600 is looping back..

I wonder just what type of Switch or Hub the design team had in mind.

307
Views
0
Helpful
1
Replies
CreatePlease to create content