Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

OEAP600 Dual-Rlan w/7.2.203 code

                   The documentation says :

Only four clients can connect thru a remote LAN port on the 600 AP.

I have network oeap-600 dual-rlan-ports enabled.

Can I now have four clients on EACH remote LAN port?

I am feeding a 2960-8, 1 rlan feeding vl2 as management and the other rlan feeding vl3 as data.

I NEED 4 mac's on data.

The answer I think is 4 clients can connect thru remote LAN(s) total, just as we have 15 across all (controller) SSIDs of a single AP.

Darn, I was hoping for 4 each.  Just not enought table space to track anymore.

1 REPLY

OEAP600 Dual-Rlan w/7.2.203 code

AH, there ARE 4 each.  Provided you are not using a 2960 like I am.

When I use a pair of Linksys grade switchs, the switch's have no presents on Layer2.

Can one dumb down a 2960 a bit and loose the vl1 and port mac hits?

I don't really need management..

454
Views
0
Helpful
1
Replies