Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

PEAP config

hello all,

I have 4404 controller running LWAPP 4.0.x code. I am tring to configure my LAB WLAN for PEAP authentication. On my laptop I am using the Microsoft supplicant

My Open and WPA-PSK is working fine. I am not able to get pEAP to work

. In the controller WLAN LAB I have configured the L2 Security for 802.1x

. I have configured my ACS

. I have added my controller to my ACS

. I have configured my laptop for PEAP with verisign cert server.

I am associated to the AP, but Ido not get an iP address from the DHCP server.

I wouldbe grateful for your assitance. A document would be nice too.

thanks

2 REPLIES
Gold

Re: PEAP config

If you assign IP to host manualy can you access network???

Did you check failed attempts (reasons) in ACS log???

M.

Re: PEAP config

On the WZC, can you verify that fast reconnect is not checked, and that the CA that issued the certificate is in the Trusted Root CA list.

On the same note, if you uncheck the Validate server certificate box, will it allow you connect?

and one last dumb questin, when you set the WLAN to use L2 802.1x security, did you select the Radius servers in the drop downs?

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
145
Views
0
Helpful
2
Replies
CreatePlease to create content