Point to Point with VLANs on 1242 only for wired how to hide SSID
Have two 1242's that I believe I configured properly as they are passing traffic and I have an IP phone working. The setup is as follows:
PC/Phone--->3750 Switch ---->non-root ap ////////\\\\\\\\\\\ root ap <-------3560 switch <-------------Main Network
Has a data vlan (VLAN 10) and a voice vlan (VLAN 20)
Sub interfaces are dot110.10 and dot110.20 along with fastethernet 0.10 and 0.20 respectively. I have two static IP's that belong to the data vlan's configured on the virtual interface for each AP.
The issue I am having is you can see the SSID. I will ONLY have hard wired PC's and Phones connected to the 3750 switch. No wireless clients at all. Is there a way to stop the SSID broadcasts? I can insert the configs if you would like.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...