Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Power Over Ethernet (PoE) not working on WLC 2504

I have connected a 2602 AP to one of the PoE-ports on a 2504 WLC running ver 7.5.102.0. But there's no PoE going to the AP, and it doesn't turn on. There's probably something I have misunderstood here so sorry for asking this stupid question, but why doesn't it work? I checked out controller>ports and all interfaces are there but no PoE.                  

Everyone's tags (3)
4 REPLIES
Hall of Fame Super Silver

Re: Power Over Ethernet (PoE) not working on WLC 2504

PoE is not available if you have LAG enabled only if it's disabled.

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
VIP Purple

Re: Power Over Ethernet (PoE) not working on WLC 2504

Scott ,
I think lag not supported on 2504 WLC , is it correct ??

Regards

Sent from Cisco Technical Support iPhone App

Hall of Fame Super Silver

Re: Power Over Ethernet (PoE) not working on WLC 2504

Cisco started supporting LAG on v7.4 which is what a lot of customer wanted. However, PoE gets disabled when LAG is enabled, so it's sort of a trade off.

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
VIP Purple

Re: Power Over Ethernet (PoE) not working on WLC 2504

Hi,
Normally port 3 and 4 are the POE ports on 2504 Wlc.
Check it again if it is right ports.

Regards

Sent from Cisco Technical Support iPhone App

1003
Views
0
Helpful
4
Replies
CreatePlease login to create content