Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

power requirements for a 1042 mesh network

this note is from the 5508 controller config manual, does this apply to 1040 access points in a mesh network?

Note:The recommended power source for MAPs is either a power supply or power injector. PoE is not a recommended power source for MAPs.

2 REPLIES

power requirements for a 1042 mesh network

No, that would be about the 15xx series of MESH AP.

Steve

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
New Member

power requirements for a 1042 mesh network

thank you much

241
Views
0
Helpful
2
Replies