I am attempting to power a Cisco Aironet AIR-BR-1310G-A-K9-R bridge using an AIR-PWRINJ-BLR2 power injector, the problem I'm having is getting power to the injector. I see that you can use AIR-PWR-A to power the injector and I was wondering if instead of running two runs of coax to the injector, if I could possibly run a longer cable from the AIR-PWR-A (split the cable on the DC side of the AIR-PWR-A and splice in 16 Awg wire). Since this is for an indoor application (Cisco Net Acad) I do not have to worry about precipitation and hence the need for running the coax. It would be much cheaper if I could run 100 ft of 16 Awg wire as opposed to 200 ft of coax. I have checked and there would be minimal power loss over 100 ft of 16 Awg (http://www.powerstream.com/Wire_Size.htm).
Any suggestions, warnings or help would be greatly appreciated, thank you.
The Power Injector also provides power to the outdoor unit over the same cables with a power discover feature and surge protection. To support longer cable runs from your wireless network switch or router, the Power Injector enables total cable runs up to 200 meters (Category 5 Cable + Coax).
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...