Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Primary and Secondary WLC

Is there a way to add controller dymanic interface by using WCS and push down to Primary and Secondary WLC?

Can I use the same IP address for Dymanic interface on both Controllers? Basically this IP address use to request DHCP for clients.

Thanks,

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: Primary and Secondary WLC

IP Address of any dynamic interfaces have to be different form each WLC. I would add the interfaces manually and not use WCS.

-Scott
*** Please rate helpful posts ***
1 REPLY
Hall of Fame Super Silver

Re: Primary and Secondary WLC

IP Address of any dynamic interfaces have to be different form each WLC. I would add the interfaces manually and not use WCS.

-Scott
*** Please rate helpful posts ***
161
Views
0
Helpful
1
Replies
CreatePlease login to create content