Welcome to Cisco Support Community. We would love to have your feedback.
For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.
I'm in need of some help, when accessing the device (Web GUI Interface) with username/password "Cisco", I can not apply changes, always returns to the default values.
In SECURITY section, the "Cisco" user privileges are read-only, no write ........
How I can change the privileges?
Thanks in advance!
Restore the Access Point’s configurations
Please follow below guide for step by step troubleshooting:
was the first thing I did to set it up again, but the problem persists.
Console port usage: The console port on LAP access points is enabled in read-only mode
LWAPP-capable access points have a read-only console port for additional diagnostic information